Ústav fyziky materiálů AV ČR, v. v. i. > Zaměstnanci > Pokorný Pavel

Ing. Pavel Pokorný, Ph.D.

Místnost108
Telefon+420 532 290 362
E-mail[javascript protected email address]
Researcher IDK-4764-2012
ORCID0000-0002-9360-9776
Pozicevědecký pracovník - Skupina vysokocyklové únavy

Odborné zaměření
  • Teoretické odhady zbytkové únavové životnosti inženýrských komponent
  • Zkoumání mechanizmů rychlosti šíření únavové trhliny
  • Experimentální testování únavových charakteristik inženýrských materiálů

Vzdělání
  • 2012-2016: Doktorské studium - Vysoké učení technické v Brně
  • 2010-2012: Inženýrské studium  - Vysoké učení technické v
  • 2007-2012: Bakalářské studium - Vysoké učení technické v Brně
Pracovní zkušenosti
  • Od 2021: Vědecký pracovník - Skupina vysokocyklové únavy, Ústav fyziky materiálů, AV ČR, v.v.i.
  • 2016-2021: Postdoktorand - Skupina vysokocyklové únavy, Ústav fyziky materiálů, AV ČR, v.v.i.
  • 2012-2016: Doktorand - Skupina vysokocyklové únavy, Ústav fyziky materiálů, AV ČR, v.v.i.
Zahraniční stáže
  • 08/2017-09/2017: Vědecká stáž - University of Hertfordshire, Velká Británie
  • 02/2014-03/2014: vědecká stáž - Politecnico di Milano, Itálie
Ocenění
  • 01/2017-12/2018: Program podpory perspektivních lidských zdrojů (PPLZ) AV ČR, v.v.i.


2025

Pokorný P., Vojtek T., Kubíček R., Jambor M., Náhlík L., Hutař P.: Paradox of shorter residual fatigue life due to omission of low-amplitude cycles and its significance for testing. Fatigue Fract. Eng. Mater. Struct. 48 (2025) 956-966



2024

Vojtek T., Kubíček R., Pokorný P., Hutař P.: Misconception of the use of 2D plane stress solutions for free surfaces of cracked bodies and its significance for full field measurement techniques. Adv. Eng. Mater. 26 (2024) 2400367

Kubíček R., Vojtek T., Jambor M., Pokorný P., Náhlík L., Pokluda J., Hutař P.: Solution to the problem of low sensitivity of crack closure models to material properties. Theor. Appl. Fract. Mech. 130 (2024) 104243

Dlhý P., Peter O., Fajkoš R., Pokorný P., Hutař P., Jambor M.: Numerical investigation of the critical areas of the freight train wheel web. Strojnicky casopis - Journal of Mechanical Engineering 74 (2024) 15-26

Kubíček R., Vojtek T., Pokorný P., Náhlík L., Hutař P.: Equations for efficient cycle-by-cycle computation of fatigue crack retardation and acceleration due to amplitude changes. Theor. Appl. Fract. Mech. 133 (2024) 104547



2023

Oplt T., Vojtek T., Kubíček R., Pokorný P., Hutař P.: Numerical modelling of fatigue crack closure and its implication on crack front curvature using deltaCTODp. Int. J. Fatigue 171 (2023) 107570

Jambor M., Vojtek T., Pokorný P., Koutný D., Náhlík L., Hutař P., Šmíd M.: Anomalous fatigue crack propagation behavior in near-threshold region of L-PBF prepared austenitic stainless steel. Mater. Sci. Eng. A 872 (2023) 144982



2022

Seitl S., Pokorný P., Benešová A., Juhászová T., Kala Z.: Variance of selected properties from various structural elements made from AISI 304. Trans. VSB TU Ostrava Ser. 22 (2022) 39-44

Kubíček R., Vojtek T., Pokorný P., Hutař P.: Sensitivity of numerically modelled crack closure to material. Procedia Struct. Integr. 42 (2022) 911-918

Dlhý P., Poduška J., Pokorný P., Jambor M., Náhlík L., Kajánek D., Fajkoš R., Hutař P.: Estimation of residual stress distribution in railway axles. Eng. Fail. Anal. 135 (2022) 106142

Dlhý P., Poduška J., Pokorný P., Jambor M., Náhlík L., Hutař P.: Residual stress determination by the layer removal and X-ray diffraction measurement correction method. MethodsX 9 (2022) 101768

Seitl S., Pokorný P., Klusák J., Duda S., Lesiuk G.: Effect of specimen thickness on fatigue crack growth resistance in Paris region in AISI 304 steel. Structural. Integr. 24 (2022) 291-297

Jambor M., Pokorný P., Trško L., Oplt T., Jacková M., Hutař P.: Microstructure and the fatigue crack propagation in the dissimilar low alloy/stainless steel GMAW welded joints. Mater. Character. 191 (2022) 112119



2021

Pokorný P., Vojtek T., Jambor M., Náhlík L., Hutař P.: Effect of Underload Cycles on Oxide-Induced Crack Closure Development in Cr-Mo Low-Alloy Steel. Materials 14 (2021) 2530

Madia M., Vojtek T., Duarte L., Zerbst U., Pokorný P., Jambor M., Hutař P.: Determination of fatigue crack propagation thresholds for steel in presence of environmental effects. Int. J. Fatigue 153 (2021) 106449

Jambor M., Vojtek T., Pokorný P., Šmíd M.: Effect of Solution Annealing on Fatigue Crack Propagation in the AISI 304L TRIP Steel. Materials 14 (2021) 1331



2020

Seitl S., Pokorný P., Miarka P., Klusák J., Kala Z., Kunz L.: Comparison of fatigue crack propagation behaviour in two steel grades S235, S355 and a steel from old crane way. MATEC Web Conf. 310 (2020) 34

Šebestová H., Horník P., Mrňa L., Jambor M., Horník V., Pokorný P., Hutař P., Ambrož O., Doležal P.: Fatigue properties of laser and hybrid laser-TIG welds of thermo-mechanically rolled steels. Mater. Sci. Eng. A 772 (2020) 138780

Pokorný P., Dlhý P., Poduška J., Fajkoš R., Vojtek T., Náhlík L., Grasso M., Hutař P.: Influence of heat treatment-induced residual stress on residual fatigue life of railway axles. Theor. Appl. Fract. Mech. 109 (2020) 102732

Fintová S., Pokorný P., Fajkoš R., Hutař P.: EA4T railway axle steel fatigue behavior under very high-frequency fatigue loading. Eng. Fail. Anal. 115 (2020) 104668

Vojtek T., Pokorný P., Oplt T., Jambor M., Náhlík L., Herrero D., Hutař P.: Classically determined effective deltaK fails to quantify crack growth rates. Theor. Appl. Fract. Mech. 108 (2020) 102608



2019

Seitl S., Miarka P., Pokorný P., Fintová S., Kunz L.: COMPARISON OF MECHANICAL PROPERTIES OF OLD STEEL FROM TRUSS CRANE RUNWAY WITH S235 AND S355 GRADES. Trans. VSB TU Ostrava Ser. 19 (2019) 56-60

Dlhý P., Poduška J., Pokorný P., Náhlík L., Fajkoš R., Hutař P.: Methodology for estimation of residual stresses in hardened railway axle. Procedia Struct. Integr. 23 (2019) 185-190

Vojtek T., Pokorný P., Kuběna I., Náhlík L., Fajkoš R., Hutař P.: Quantitative dependence of oxide-induced crack closure on air humidity for railway axle steel. Int. J. Fatigue 123 (2019) 213-224

Kunz L., Pokorný P., Konečná R., Nicoletto G.: Propagation of long fatigue cracks in Ti6Al4V alloy produced by direct metal laser sintering. Procedia Struct. Integr. 17 (2019) 222-229

Oplt T., Hutař P., Pokorný P., Náhlík L., Berto F.: Numerical evaluation of plasticity induced crack closure in 3D structures. Procedia Struct. Integr. 23 (2019) 101-106

Seitl S., Miarka P., Pokorný P., Klusák J.: Influence of corrosion on fatigue behaviour of old crane runway steel. J. Strain Anal. for Engin. Design 54 (2019) 416-423

Oplt T., Šebík M., Berto F., Náhlík L., Pokorný P., Hutař P.: Strategy of plasticity induced crack closure numerical evaluation. Theor. Appl. Fract. Mech. 102 (2019) 59-69

Oplt T., Hutař P., Pokorný P., Náhlík L., Chlup Z., Berto F.: Effect of the free surface on the fatigue crack front curvature at high stress asymmetry. Int. J. Fatigue 118 (2019) 249-261

Vojtek T., Pokorný P., Náhlík L., Herrero D., Hutař P.: Crack Closure in the Near-threshold Region in Metallic Materials. Procedia Struct. Integr. 23 (2019) 481-486



2018

Seitl S., Miarka P., Pokorný P., Fintová S., Klusák J.: Influence of Micro-Structure on the Fatigue Crack Propagation in Bridge Steel. Proceedings 2 (2018) 1-6



2017

Pokorný P., Vojtek T., Náhlík L., Hutař P.: Crack closure in near-threshold fatigue crack propagation in railway axle steel EA4T. Eng. Fract. Mech. 185 (2017) 2-19

Pokorný P., Hutař P., Náhlík L.: Influence of Extension of Load Spectrum on Estimation of Residual Fatigue Lifetime of Railway Axle. Solid State Phenom. 258 (2017) 607-610

Náhlík L., Pokorný P., Ševčík M., Fajkoš R., Matušek P., Hutař P.: Fatigue lifetime estimation of railway axles. Eng. Fail. Anal. 73 (2017) 139-157

Konečná R., Kunz L., Pokorný P., Nicoletto G.: Fatigue Crack Growth and Threshold Behavior of DMLS Ti6Al4V. Solid State Phenom. 267 (2017) 157-161

Hutař P., Pokorný P., Poduška J., Fajkoš R., Náhlík L.: Effect of residual stresses on the fatigue lifetime of railway axle. Procedia Struct. Integr. 4 (2017) 42-47



2016

Štegnerová K., Náhlík L., Hutař P., Pokorný P., Majer Z.: Influence of Residual Stresses and Particle Properties on Mechanical Response of The Material in Particulate Ceramic Composites. Key Eng. Mater. 713 (2016) 212-215

Pokorný P., Hutař P., Náhlík L.: Residual fatigue lifetime estimation of railway axles for various loading spectra. Theor. Appl. Fract. Mech. 82 (2016) 25-32

Pokorný P., Náhlík L., Hutař P.: Influence of variable stress ratio during train operation on residual fatigue lifetime of railway axles. Procedia Struct. Integr. 2 (2016) 3585-3592

Náhlík L., Pokorný P., Ševčík M., Hutař P.: Influence of Initial Inclined Surface Crack on Estimated Residual Fatigue Lifetime of Railway Axle. J. Multiscale Model. 7 (2016) 1640007



2015

Pokorný P., Náhlík L., Hutař P.: Influence of Threshold Values on Residual Fatigue Lifetime of Railway Axles under Variable Amplitude Loading. Procedia Eng. 101 (2015) 380-385



2014

Pokorný P., Náhlík L., Hutař P.: Influence of Different Crack Propagation Rate Descriptions on the Residual Fatigue Lifetime of Railway Axles. Key Eng. Mater. 627 (2014) 469-472

Náhlík L., Pokorný P., Hutař P.: Influence of crack retardation on fatigue crack propagation in steels for railway axles. Adv. Mater. Res. 891-892 (2014) 351-356

Náhlík L., Pokorný P., Hutař P., Matušek P.: Fatigue crack propagation in steels for railway axles. Key Eng. Mater. 592-593 (2014) 254-257

Pokorný P., Náhlík L., Hutař P.: Comparison of different load spectra onresidual fatigue lifetime of railway axle. Procedia Eng. 74 (2014) 313-316

Pokorný P., Náhlík L., Ševčík M., Hutař P.: Effects of variable loading on residual fatigue life of the railway wheelset. Key Eng. Mater. 577-578 (2014) 121-124